ECE 202 Lab 5 Poles & Zeros, Impulse Response II Prelab 1. Assuming the initial conditions are zero, determine the transfer function H(s), for the circuit shown below. Also, inverse transform the transfer function to obtain the impulse response for the circuit, h() IN(S) 100? 1mH V out IN 0.01 ?F 2 What values of corespon o the poles and aeros df H)7 What yoe of signal will produce zero steady state output? constant) for this circuit? produce a zero steady-state output. 3. What is the impulse response of the circuit? What is the value of t (the time 4. Build the circuit in multisim and confirm that the signal you chose in 2. will 5. As with Lab 4, measure an estimate of the impulse response of the circuit by setting up the multisim function generator to produce a pulse train where the time between pulses (i.e. the period) is long compared to the circuit’s time constant (ie. T-St), the pulse width is narrow (e.g. At-r/20) and the amplitude is the function generator’s maximum. Document the values you use for the pulse width and time between pulses.