-
What is the minimum work interaction required to compress the gas in one tank to 3 bar?
Two storage tanks (0.1 m3 each) contain air at 2 bar. They are connected across a small reversible compressor. The tanks, connecting lines, and compressor are immersed in a constant temperature bath at 280 K. The compressor will take suction from one tank, compress the gas, and discharge it to the other tank. The gas is…
-
Identify factors included in the idealized calculation of part (a) that contribute to irreversibilities.
A 2m3 tank is at 292 K and 0.1 MPa and it is desired to pressurize the tank to 3 MPa. The gas is available from an infinite supply at 350 K and 5 MPa connected to the tank via a throttle valve. Assume that the gas follows the ideal gas law with a constant heat…
-
Estimate the minimal work requirement (J/g) for the compressor assuming the ideal gas law.
An ordinary vapor compression cycle is to be operated on methane to cool a chamber to 112 K. Heat is rejected to liquid ethylene at 160 K. The temperatures in the coils are 168 K and 100 K. (ANS. online) (a) Write the relevant energy and entropy balances for the compression step. (b) Estimate the…
-
Determine the thermal efficiency, heat required, and net work output per mole of air assuming
A Brayton gas turbine typically operates with only a small amount of fuel added so that the inlet temperatures of the turbine are kept relatively low because of material degradation at higher temperatures, thus the flowing streams can be modeled as only air. Refer to the online supplement for stream labels. Consider a Brayton cycle…
-
Derive the energy balance for a closed, constant-volume, adiabatic-system vapor phase chemical reaction, neglecting the energy of mixing for reactants and products, and assuming the ideal gas law.
(a) Derive the energy balance for a closed, constant-volume, adiabatic-system vapor phase chemical reaction, neglecting the energy of mixing for reactants and products, and assuming the ideal gas law. (b) Suppose that a 200 L propane tank is at 0.09 MPa pressure and, due to an air leak, contains the propane with a stoichiometric quantity…
-
Which real root (smallest, middle, or largest) represents this phase at the highest pressure, and what are the Z values at the specified pressures?
When cubic equations of state give three real roots for Z , usually the smallest root is the liquid root and the largest is the vapor root. However, the Peng-Robinson equation can give real roots at high pressure that differ from this pattern. To study this behavior, tabulate all the roots found for the specified…
-
Describe what would happen to your flask of hot water under these conditions and a simple precaution that you might take to avoid these consequences
Within the two-phase envelope, one can draw another envelope representing the limits of supercooling of the vapor and superheating of liquid that can be observed in the laboratory; along each isotherm these are the points for which T = 0. Obtain this envelope for the Peng-Robinson equation, and plot it on the same figure as…
-
Describe how the disks would move about. Note that the slow particles would always stay slow, and the fast particles stay fast.
Suppose you had a program to simulate the motions of four molecules moving in 2D slowly enough that you could clearly see the velocities of all disks. (Hint: The Piston-Cylinder applet in the DMD module at Etomica.org is an example of such a program when kept in “adiabatic” mode.) (a) Let the disk interactions be…
-
Contrast the appropriateness of the different sources of finance to a business.
FIN4001 Introduction to Finance Assignment Date for Submission: Please refer to the timetable on ilearn (The submission portal on ilearn will close at 14.00 UK time on the date of submission) Page 1 of 13 [1291] Assignment Brief As part of the formal assessment for the programme you are required to submit an Introduction to…
-
Microeconomics You are required to identify, discuss and analyse the core microeconomic contents and write a report covering all the relevant concepts discussed in class.
Microeconomics You are required to identify, discuss and analyse the core microeconomic contents and write a report covering all the relevant concepts discussed in class. You will only focus on microeconomic environment to address the issue. The length of your report is 2000 words. Your report should have sound academic references (minimum 6 references); your…