Uncategorized
What should be the outside diameter of this disk brake?
1.A disk brake is to be constructed for use on a highspeed rotor balancing machine. It has been decided that a carbon-graphite friction material…
Author: <span>admin</span>
Uncategorized
determine the proper num-ber of friction interfaces to use for this proposed clutch.
1.For use in a specialized underwater hoisting application, it is being proposed to design a disk clutch with a 20-inch outside diameter. Hard-drawn phosphor…
Uncategorized
Calculate the required torque capacity.
A cone clutch having a cone angle of 10 is to transmit 40 horsepower continuously at a rotational speed of 600 rpm. The contact…
Uncategorized
What initial tension would be required for proper operation?
1.A flat belt drive system is to be designed for an application in which the input motor shaft speed (driving pulley) is 1725 rpm,…
Uncategorized
If 50 horsepower is to be transmitted at a pulley speed of 320 rpm, what belt width should be specified?
1.A flat belt drive consists of two cast-iron pulleys, each 4 feet in diameter, spaced 15 feet apart, center-to-center. The belt is to be…
Uncategorized
Propose a V-belt drive arrangement that will provide a mean life of about 1 year between belt replacements.
1.A 1725-rpm 5-horsepower high-torque electric motor is to be used to drive a woodworking table saw in a storm-window manufacturing plant. The saw is…
Uncategorized
Based on the knowledge that it takes about five hours to change out the main drive belt, would you consider the replacement interval estimate in (a) to be acceptable?
1. A D-section V-belt is to be used to drive the main power shaft of an agricultural combine (an agricultural combine may be regarded…
Uncategorized
What type of lubrication should be used for this application?
1.A five-strand no. 40 precision roller chain is being proposed to transmit power from a 21-tooth driving sprocket that rotates at 1200 rpm. The…
Uncategorized
estimate the “additional stretch” that would occur in the rope if a 750-lb load were being lowered at the rate of 2 ft/sec, and when the load reaches a point 10 feet below the 7.0-inch drum, a brake is suddenly applied.
1.It is desired to market a small air-driven hoist in which the load is supported on a single line of wire rope and the…
Uncategorized
estimate the number of lifts that could be safely made under the mixed loading described in (b). Again, use a fatigue safety factor of 1.25 in your estimating procedure.
1. An electric hoist, in which the load is supported on two lines, is fitted with a -inch improved plow steel (IPS) wire rope…